Filter
Top Products
CALL TOLL FREE 1-800-DR-OWNER 37
CHAPTER 6
TROUBLESHOOTING
Most problems are easy to fix. Consult the troubleshooting table for common problems and their solutions.
If you continue to experience problems call Country Home Products, Inc. for support.
Troubleshooting Table
BEFORE PERFORMING ANY MAINTENANCE PROCEDURE, STOP THE ENGINE AND DISCONNECT THE
SPARK PLUG WIRE(S).
SYMPTOM POSSIBLE CAUSE
Recoil will not pull
out or is difficult to
pull.
⇒ Check that the Blade Engage/Disengage Switch is pushed DOWN to the
Disengaged position.
⇒ The recoil may be broken or jammed. Try to turn the engine pulley by hand, with
the spark plug wire(s) off. If it turns, the recoil is broken or jammed. Call 1(800)
DR-OWNER (376-9637) for assistance.
The engine won’t
start manually. (if
equipped)
(Please refer to the
engine owner’s
manual for engine-
specific procedures.)
⇒ Check that the Fuel Shut-Off Valve is turned ON (Figure 1 on page 12), if your
machine is equipped with one.
⇒ Are you using fresh, clean gas? If the gas is old, change it. Use a fuel stabilizer if
you keep gas longer than two months.
⇒ Check the Fuel Filter to see if it is clear. Place a can under the Fuel Filter and
remove the fuel line from the engine side of the Filter. If gas flows freely, it’s OK.
⇒ Check the throttle adjustment and travel.
⇒ Is the Blade Engage/Disengage Switch pushed DOWN to the Disengaged
position and Shift Lever in NEUTRAL? They should be.
⇒ Is the spark plug(s) clean? If the spark plug(s) is dirty or cracked, change it. If it’s
oily, leave it out, hold a rag over the plug(s) hole and pull the recoil cord several
times to blow out any oil in the cylinder, then wipe off the plug(s) and reinsert it.
⇒ If your engine still won’t start, call 1(800) DR-OWNER (376-9637) for assistance.