Filter
Top Products
26 DR
®
FIELD and BRUSH MOWER
Figure 11
Figure 13
Figure 12
Lubricate Chain
1. There is one grease fitting below the black Belt Guard
that needs lubrication (Figure 11):
• The Belt Idler Arm should have 1-2 pumps of
grease every 25 operating hours.
NOTE: Over greasing will cause grease to leak out of the
seals onto the mower drive belt. Unless
instructed otherwise, pump only until you feel
slight resistance (1-2 pumps).
2. The Drive Chain should be lubricated with FLUID
FILM
®
lubricant or SAE 30 oil every 25 operating
hours—more often if the machine is operated in
extremely dusty or wet conditions. Remove the
Chain Cover, lubricate the Chain and replace the
cover (Figures 12 and 13).
3. Place the Differential Lock In/Out Lever in the OUT
position.
4. Clean the Lock In/Out Sleeve Shaft of any
accumulated grass and debris with a cloth and
lubricate the Shaft using FLUID FILM
®
lubricant
or SAE 30 oil (Figure 14).
5. Move the Differential Lock In/Out Lever back and
forth a few times to distribute the lubricant on the
Lock In/Out Sleeve Shaft.
Belt Idler Arm Grease Fitting
Remove Chain Cover
Figure 14
Lubricate Shaft here
Lock In/Out Sleeve