Filter
Top Products
ASSEMBLY & INSTALLATION
12 DR
®
SNOW THROWER Safety, Operation & Maintenance Instructions
!
WARNING: Before installing the DR
®
SNOW THROWER, always bring the DR
®
ALL-
TERRAIN
™
MOWER to a complete stop, shut
off the engine and remove the spark plug wire.
Step 3: Installation (Figure 3)
1. Remove the mowing deck from the DR
®
ALL-TERRAIN
™
MOWER.
2. Apply grease on the shaft (item 6).
3. Remove bolts (item 5) from belt cover.
4. Remove the belt cover (item 4).
5. Align the DR
®
ALL-TERRAIN
™
MOWER
and DR
®
SNOW THROWER. Carefully,
insert the shaft (item 6) of the ALL-
TERRAIN
™
MOWER into the female
attachment on the SNOW THROWER.
6. Reinstall the collar and pin used with the
mower to secure the SNOW THROWER.
Step 4: Belt Installation (Figures 3 & 4)
1. Carefully install the drive belt (item 1)
around the drive pulley (item 2) under the
DR
®
ALL-TERRAIN
™
MOWER.
2. Pull the tensioner (item 3) to reinstall the
belt on the idler. Make sure that the V-belt is
not twisted and fits correctly in the V-groove
on the pulley.
3. Make sure to position the belt above the belt
guide, as shown in figure 4.
4. Reinstall the belt cover (item 4) and bolts.
Fi
g
ure 3
Figure 4