Filter
Top Products
SKU 95283 For technical questions, please call 1-800-444-3353 PAGE 17
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY
DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE
OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER
AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD
BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER
ASSUMES ALL RISKS AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL
PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF
REPLACEMENT PARTS THERETO.
TROUBLESHOOTING
Problem Possible Cause Possible Solution
Guard Bar and Chain running hot and
smoking.
1. Chain tension too tight.
2. Chain Oil Tank empty.
1. Re-adjust Chain Tension Adjusting Screw to
lesson tension on Chain.
2. Refill Chain Oil Tank.
Engine runs, but Chain is not rotating. 1. Chain tension too tight.
2. Damaged Guard Bar and/or
Chain.
1. Re-adjust Chain Tension Adjusting Screw to
lesson tension on Chain.
2. Have a qualified service technician repair or
replace Guard Bar and/or Chain.
Chain rotates while Engine is at idle. 1. Engine idle speed set too
high.
1. Have a qualified service technician reset
Carburetor idle adjustment Screw to lower
idle (RPM) speed.
Power Switch does not turn off
Engine.
1. Defective Power Switch. 1. Immediately remove Spark Plug Cap from Spark
Plug to stop Engine. Discontinue using Polesaw/
Pruner until the tool is repaired by a qualified
service technician.