Filter
Top Products
SKU 92880 For technical questions please call 1-800-444-3353 Page 7
Installing the Battery Pack
1. Place the battery pack in the tool,
aligning the arrows on the battery
pack with the arrows on the tool.
2. Press the battery pack into the
tool. Make sure that the battery
pack snaps into place, and that the
battery pack is secure in the tool
before beginning use.
Removing the Battery Pack
1. Press the Release Tabs (19) on both sides of the battery pack to release the
battery from the tool.
2. Remove the battery pack from the tool by pulling straight out.
Inserting or removing a bit from the tool.
Note: Only use accessories that are rated at or above the RPM rating of the
Cordless Rotary Tool.
WARNING: Always allow the motor to come
to a complete stop before engaging the
spindle lock.
WARNING: Always remove the battery pack
before making any adjustments or changing
bits, to prevent accidental starting of the tool.
Accidental starting of the tool may result in
serious personal or property injury.
1. Depress the Spindle Lock (10). Rotate
collet until shaft is engaged by the lock.
2. Loosen the Collet Nut (1) by turning it
counterclockwise, using the Wrench
provided.
WARNING: If you are changing a bit immediately after use, be careful not to
touch the bit. It may be very hot from use, possibly causing injury. Allow the bit
time to cool before handling it.
3. To remove a bit: Pull the bit straight out of the Collet once the Collet Nut is
loose. To insert a bit: Insert the shank end if the bit into the Collet once the
Collet Nut is loose.
Spindle Lock (10)
Collet Nut (1)
Wrench