Filter
Top Products
SKU 92880 For technical questions please call 1-800-444-3353 Page 9
Operation
1. Charge the Battery Pack (18) and insert it in the tool, as described in the
previous section.
2. Select an appropriate bit or attachment
for the job. Insert the bit or attachment as
described in the previous section.
3. The LED Lighted Collar may be turned on by
moving the switch on the collar.
4. Rotate the Switch (8) to the ON position.
NOTE: This is a variable speed switch. The
tool bit speed is dependent on the position
of the Switch. Use a speed appropriate to
the bit and the material being worked on.
In general harder materials require faster
speeds and softer materials require slower speeds. Relative speeds are
indicated by the numbers on the Switch.
5. Apply the tool bit to the work material as needed.
6. When the task has been completed, stop the tool by rotating the Switch (8) to the OFF
(“O”) position. If the LED Collar light is ON, switch it OFF. Unplug the rechargeable
battery. Remove the bit or attachment as discussed in the previous section.
7. Store the tool, its battery, and its bits and attachments in their case in a safe location.
8. Dispose of used batteries properly. Consult your local hazardous waste
authority for disposal guidelines.
Maintenance
1. A plastic storage case has been provided for safe storage of your Rotary
Tool and its bits, parts and accessories. Always store your tool and its
accessories in the case provided.
2. Protect the tool and its parts and accessories from moisture and damp or
corrosive atmospheres.
3. Keep this tool out of reach of children and other unauthorized persons.
4. Protect this tool from damage. Do not leave it in a place where it can be
banged around, such as a truck bed or vehicle trunk.
5. Some of the bits provided are “grinding bits” using stone abrasives. During
use, these may clog up with removed material or lose their shape. To clean
and reshape these bits, run them against the provided Dressing Stone. The
Dressing Stone will abrade away the clogging materials and will reshape the
Grinding Bits as appropriate.
Switch