Filter
Top Products
SKU 92880 For technical questions please call 1-800-444-3353 Page 8
NOTE: Your tool is provided with two collets, 1/8” and 1/4” diameter. These are
precision manufactured to t comparably sized bits. Do not force a bit into
the wrong sized collet, nor do not modify a mismatched collet or bit.
Severe personal or
property damage may
result from using
mismatched collets or
bits.
4. Tighten Collet Nut securely
using the provided wrench.
Ensure that the spindle lock
is released before turning on the tool.
WARNING: Be sure the Collet Nut is tight before turning on the tool. Bits may be
ejected from a tool if the Collet Nut is loose, potentially causing severe personal
or property damage.
Installing or Removing the LED Collar
1. The Front Collar (3) is interchangeable
with the LED Lighted Attachment (23).
To install the LED Lighted Attachment,
remove the standard collar by turning
counterclockwise, and install the LED
Lighted Attachment by turning clockwise.
2. When installing or removing, use only
hand pressure and tighten rmly by
hand. Do not overtighten, as this may
damage the part.
3. To change the batteries in the LED Lighted Attachment, rst remove it from
the Rotary Tool.
4. Using a phillips
screw driver, open the
battery compartment.
5. Replace the
batteries with the
same type as
originally installed
(Two CR-927 3 VDC
batteries). Be sure
to match the polarity
marking in the battery
compartment.
Collet size must match tool shaft diameter.
Collet Nut Collets
Battery