Filter
Top Products
SKU 92880 For technical questions please call 1-800-444-3353 Page 6
Battery Temperature Warning:
WARNING: Battery explosion may cause serious
personal or property injury including death. Charge the
battery only within a 50° to 100° temperature range.
Lower temperatures may inhibit charging. Higher
temperatures increase chance of battery failure,
including explosion.
2. Charge the battery pack only with the included
Charger Base (25). Use of other chargers may
cause battery failure including explosion.
3. Ensure that the Charger Base (25) is connected to
a circuit breaker protected 120 VAC, 60 Hz power
supply only.
4. Connect the Charger Base to the Transformer (24),
by plugging it in as shown in the photo. Plug the
Transformer (24) into a 120 VAC wall outlet.
5. Insert the battery pack into the Charger Base (25) by aligning the ribs on the
battery pack with the grooves in the battery pack. Press the battery pack into
place.
NOTE: The Battery has Release Tabs (19) on both sides. Press these in to
release the battery from the Rotary Tool or from the Battery Charger Base
(25).
6. Press down on the battery pack to make sure that the contacts on the
battery pack are fully engaged with the contacts in the charger unit.
7. While being charged, the green LED will be lit, indicating that the charger is
in operation. During recharging, the battery pack will become slightly warm
to the touch. This is normal and not a cause for concern.
8. Do not place the battery and charger in an environment of extreme heat or
cold. They will work best at room temperature.
9. Note: The Charger Base (25) will not shut off automatically. When the
battery is fully charged (after 3 to 3-1/2 hours), unplug the battery charger
and remove the battery pack. Do not leave the battery in the Charger Base
(25) indenitely.
REV 07h
Transformer (24)