Filter
Top Products
Operation
Legend 300E Spot User Manual Rev. 01g -11-
4. Operation
Control Panel
Description
Button Function
<MENU> Exits from the current menu or function
<ENTER>
Enables the currently displayed menu or sets the currently selected
value in to the current function
<UP>
Navigates upwards through the menu list and increases the numeric
value when in a function
<DOWN>
Navigates downwards through the menu list and decreases the
numeric value when in a function
LCD Display
The Legend 300E Spot features a backlit liquid crystal display (LCD) that provides
plenty of information regarding the fixture’s settings and status. In addition, the LCD is
reversible. This allows reading it normally whether the fixture is on the floor or hanging
from a truss.
Upon power up, the LCD will show the Legend logo and the fixture identification, as
shown on the left figure above. After completing the power up tests, the LCD will show
the DMX address, the DMX mode, and the temperature, along with the warning sign if
the tests have detected an error.
Press <ENTER> to read the corresponding error message (see Error Messages in
the Technical Information section).
Press <ENTER> while looking at the error messages to clear them.
Control Options
You can set the Legend 300E Spot start address in the 001~512 DMX range. This
allows for the control of up to 17 fixtures in the 29-channel Mode 2. The Legend 300E
Spot works with any compatible DMX controller using standard DMX cables or the
optional W-DMX receiver.
Programming
Carry out all the programming procedures indicated below from the control panel. Refer
to the Menu Map page to learn how the menu options relate to each other
Navigation Buttons
To enter programming mode, press <MENU> until you see the Main Menu.
To highlight a menu option or to change a setting, press <UP> or <DOWN>.
To change menu levels as shown in the Menu Map, press <ENTER> or <MENU>. This
is equivalent to moving right and left of the Menu Map, respectively.
To accept the current or new value, press <ENTER>.
To return to the previous menu without making changes, press <MENU>.
To exit programming mode, press <MENU> until you see the Main Menu or do not press
any button for 30 seconds.