Filter
Top Products
Setup
-8- Legend 300E Spot User Manual Rev. 01g
Gobo
Replacement
The gobos in the Legend 300E Spot’s gobo wheel are removable from their gobo plates.
This operation is quite simple, although it requires the technician to be careful and to
follow the recommended procedure.
· Make sure to disconnect the fixture’s power cord before replacing a gobo
· Always replace a gobo with a gobo of the same dimensions.
· When inserting a glass gobo, always make sure that the shiny side of the
gobo (glass base) faces the lamp. This provides a layer of protection against
the high temperature from the lamp.
Procedure
1) Turn the fixture off and disconnect it from the power outlet.
2) Open the head cover by loosening the four fastening screws at the sides of the top
cover.
3) Separate the gobo plate away from the gobo wheel by pushing it toward the front of
the moving head (direction 1 in the diagram). Be careful not to push the gobo out of
the gobo plate.
4) Extract the gobo plate by pulling it outward (direction 2 in the diagram).
5) On a flat surface, remove the expansion ring that holds the gobo in place and
remove the gobo from the gobo plate.
6) Insert a new gobo and hold it in place with the expansion ring.
7) Slide the tip of the gobo plate under the pressure plate near the center of the gobo
wheel.
8) Push the gobo plate inwards. DO NOT force the gobo plate into the gobo wheel slot.
If correctly installed, the gobo plate should accommodate itself in the gobo wheel
slot.
Gobo Replacement
Diagram