Filter
Top Products
15
DC Control
OPERATION SPEED CONTROL
There are six individual speed settings for the fan. Each speed is indicated
by the number on the controller. To properly calibrate all speeds of the
motor, run the fan on speed "6" for 90 seconds after each AC power reset.
To select the desired fan speed:
Press the number on the controller corresponding to the speed desired. is
off.
Note: It is normal for the fan to start in the "High" position from "Off" before
changing to the selected speed.
OPERATION REVERSING AIRFLOW
The direction of airow can be changed from downward to upward
or from upward to downward.
To reverse the airow:
1. Make sure the fan is on and blades are turning.
2. Press the reverse button. The fan will stop and teeter back
and forth and then change directions.
To turn the lights off and on, press and release the button for less
than one second.
To dim the light, Press and hold the button for more than 1
second. The light will come on at the last brightness setting and
increase in brightness until full power is reached, then start dimming
until the lowest setting is reached. This cycle will repeat until you
release the light button.
The product contains several safety features:
• If the blades are obstructed during use, the motor will turn off within 3 seconds of interruption. If this
occurs, simply reset motor by turning power off at the circuit breaker of fuse box and then back on.
• When the receiver detects power consumption greater than 80 Watts, power to the fan will be
stopped, simply restart fan by selecting desired speed on control.
OPERATION LIGHTS
Note: The dimming feature will only work as long as the dimming feature remains active. See "Operation
CFL mode".