Filter
Top Products
11
steaLth
®
dc
MOTOR
HOUSING
ASSEMBLY
HANGING THE FAN
Step 1. To hang the fan body in the canopy,
hold the fan body rmly and insert the ball into
the canopy opening as in Figure #1. Check that no
wires are pinched. Rotate the fan body until the
slot in the ball ts into the pin opposite the canopy
opening in Figure #2.
FIGURE 1.
FIGURE 2.
Slot
Pin
Step 2. Trim excess motor wires, leaving at least 6
inches above the downrod. Strip 1/2-inch insulation
from the end of each wire using a wire stripper
(available at your local hardware store).
Step 3. Attach the fan wires to the ceiling xture
outlet box wiring by placing the bare ends of the
wires side by side and then securing with a wire
nut. Test that the connection is secure by pulling on
the wire nut. Connect in this order:
• GREEN leads from mounting plate and downrod
assembly of fan to GROUND conductor of power
source. Secure with wire nut.
• WHITE wire from fan to white NEUTRAL wire in
ceiling xture outlet box. Secure with wire nut.
• BLACK power wire from fan to BLACK power
wire in ceiling outlet box. Secure with wire nut.
NOTE: If the color of your ceiling wires differs from
that described, consult an electrician.
2 BLACK WIRES
2 WHITE WIRES
GREEN
WIRES
FIGURE 3.
CANOPY ELECTRICAL CONNECTIONS