Filter
Top Products
10
CAUTION: The Motor Adapter has a special
coating on the threads. Do not remove this
coating; the coating prevents the downrod
from unscrewing. Once assembled, do not
remove the downrod.
Step 2. Route the wires through the 3"
Perma•Lock downrod and ball assembly as shown
in Figures #3. Insert the downrod into the motor
coupling and turn it clockwise until it stops turning,
ensuring that the pole has bottomed out.
Step 3. Tighten the set screw using the provided
allen wrench.
Tip: The downrod has a tapered thread that
is designed to lock completely when installed
correctly. Tighten the set screw as shown in Figure
#4 with the included allen wrench to ensure
safe operation of your fan. If it is tight enough,
you should not be able to turn the downrod
counterclockwise with your hands. If in doubt,
tighten the set screw until you cannot turn it any
further.
CAUTION: Failure to fully lock in the
downrod before securely tightening the
set screw may cause the fan to separate
from the downrod and fall during normal
operation.
FIGURE 3.
TAPERED
THREAD
MOTOR
COUPLING
MOTOR WIRES
(LEAVE AT LEAST
6" LONG)
PERMA•LOCK™
DOWNROD AND
BALL ASSEMBLY
MOTOR
HOUSING
ASSEMBLY
SET SCREW
Set Screw
FIGURE 4.