Filter
Top Products
9
Co t t a g e
™
We t
BLADE BADGE AND BLADE HOLDER INSTALLATION
CAUTION:
Blade screws must be tightened securely before
operating the fan.
Step 11a. Carefully tilt the blade holder between the switch
housing motor plate and the motor, as shown.
TIP: Rotate the motor beneath the switch housing plate
to attach the blade/blade holder assembly.
Step 11b. Using the screws from Screw Pack D, the screws
removed in Step 9, and the screwdriver provided, attach
the blade/blade holder assembly to the motor. Tighten
securely by hand only.
Step 11c. After all blade holders are installed, install the
gasket into the switch housing mounting plate. e smooth
side of the gasket should face the fan motor.
TIP: For balancing purposes, loosely install all five blades
to the motor before tightening the blade screws securely.
Preparation
Step 12. Locate the switch housing cap assembly and
remove the two 8-32 x 3/8” screws holding the cap onto
the switch housing. Remove the cap and gasket.
NOTE: Save the two screws — they will be used in Step
15.
CAUTION:
Handle the gasket carefully to avoid tearing.
Switch Hous-
ing Gasket