Filter
Top Products
5
Co t t a g e
™
We t
(not to scale)
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either the circuit
breaker or fuse box), lower the old fixture and disconnect
the wiring. Check the ceiling fixture outlet box to be sure
it is marked “Approved for Ceiling Fan Mounting.” If it is
not, a new box must be installed.
GETTING STARTED
Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fixture located where you wish
to place your Casablanca fan, an approved ceiling fixture
outlet box must be installed and wired.
NOTE: e weight of this fan is 18 pounds.
Crossbar Mounting Bracket
Screw Pack A:
WARNING!
To reduce the risk of fire, electrical shock, or
personal injury, mount to outlet box marked
“Acceptable Fan Support of 22.7 kg (50 lbs.) or
less” using the mounting hardware provided with
the outlet box.
Canopy Gasket
Hanging Plate
Step 2. Fit the hanging plate into the canopy gasket as
shown. Make sure that the four holes of the hanging
plate align with the four indentations on the inside of
the gasket.
Canopy
Gasket
Hanging
Plate
Mounting
Bracket
Screw Hole
Proceed with installation as follows:
Step 3. Route the wires from the ceiling outlet box through
the center hole of the canopy gasket and hanging plate and
then the crossbar mounting bracket center hole.
Push the mounting hardware included with the outlet
box through the rubber canopy gasket so that the screws
align with the threaded holes of the ceiling fan approved
outlet box.
Using the screwdriver, tighten the screws firmly by hand
only, being careful not to bend the bracket by over-
tightening.
CAUTION:
To reduce the risk of personal injury, use only the
mounting hardware provided with the approved
outlet box to install the crossbar mounting
bracket.
Ceiling Fan
Approved
Outlet Box
-
ing
Ridge
Side
Down
Green
Crossbar
Mounting
Bracket
Canopy
Gasket &
Hanging
Plate
Outlet Box
Mounting
Hardware