Cal Spas LTR20101001 Hot Tub User Manual


 
2010 Portable Spa
LTR20101001, Rev. B
Operating Your Spa
www.calspas.com
20
Diverter Knobs
Diverter knobs are
the larger knobs
located around
the top of your
spa. They allow
you to divert water
through jets from
one side of the spa
to the other, or in
most cases from
oor jets to wall
jets. This is accomplished by rotating the diverter
knob to the left (counterclockwise), decreasing the
amount of water ow through a section of jets.
To increase the amount of water ow through the
other section of jets, rotate the handle to the right
(clockwise).
Air Venturis
Air venturis are the
smaller knobs located
around the top of your
spa. They can also
be distinguished from
diverter knobs by the
arrows and the words
“OFF”, “ON” and “AIR”
marked on them. Each one will let you add a mixture
of air with the jet pressure. This is accomplished by
rotating the air venturi knob to the left (counter-
clockwise) to increase the amount of airow through
the jets. To decrease the amount of airow through
the jets, rotate the handle to the right (clockwise).
Adjustable Therapy System™
Pump On/Off
This button allows
the user to turn on
and off the ATS™
seat pump. Press
this button once to
turn the pump on.
Once on, the green
LED light on the
control panel will
illuminate, indicating
that the system is
operational. To turn off the pump, press the “PUMP
ON/OFF” button a second time. Note: The pump must
be on prior to operating any other features of this
system.
Pulse Mode
This button allows the user to turn the ATS™ massage
control on and off. Press the pulse button once to turn
on the massage control. Once pressed, the orange LED
in position number 1 will light, indicating the number
one pulse mode. Each press of either the up or down
button will move the orange LED up or down to the
next pulse mode.
Note: Allow one second between each button press.
Pressing the button quickly may cause improper
operation. To turn the pulse mode off and return to
normal pump operation, press the “PULSE MODE”
button a second time.
Up
This button allows the user to cycle up from one
through seven massage modes one at a time. Each
mode offers a different pulsating massage. Some
modes are faster than others, so just cycle through
them to nd the massage you like best.
Down
This button allows the user to cycle down through all
seven massage modes, one at a time.
Time Reset Mode
Pulse mode will normally run for 15 minutes then
automatically shut off. For another 15-minute session,
press the “PUMP ON/OFF” button and the “PULSE
MODE” button. A green LED will blink and the pump
will run on high-speed mode as part of a 15-minute
cool down period. After that, the pump will stop