Filter
Top Products
2010 Portable Spa
LTR20101001, Rev. B
Operating Your Spa
www.calspas.com
12
Initial Start up
When rst powered up, it will automatically revert to
Priming mode. A Pr on the topside display will indicate
this. Priming mode will be active for less than ve
minutes at which time the heater will be activated and
the water temperature will be maintained in Standard
mode. The spa will heat to 37.5°C at start up until the
set temperature is changed as described below.
Temperature Adjustment
(Range 26°C to 40°C)
The electronic control panels display the actual
water temperature in degrees Celsius. The displayed
temperature will only be current after the pump has
been running for at least 2 minutes.
To display the temperature that the spa is set to:
Press the Temp button. The temperature •
setting will ash.
While the display is ashing, each time you •
press Temp button, the set temperature
will change up or down one degree.
If the desired temperature is opposite •
of the direction each press of the button
is making, release button, allow display
to stop ashing and then press Temp
button to change temperature the other
direction.
Standard, Economy and Sleep
Heating Modes
Your new spa is equipped with a heating feature that
gives you complete control of the heating system.
When the spa is powered up, it will automatically start
in standard heating mode.
St will light briey on the main display. In this mode, •
the heating system will automatically maintain
the set spa temperature. In the economy-heating
mode, the heating system will only activate during
ltration times.
Ec will display solid if temperature is not current •
and will alternate with spa temperature if measured
temperature is current.
Economy mode will heat the water to the set •
temperature while Sleep mode, indicated by a
SL on the main display, will also only activate the
heater during the ltering cycles but will only heat
the water to within 10°C of the set temperature.
6105 and 6205 Electronic Control Operation
Operating Your Spa
Like Economy mode, SL will display solid when
temperature is not current and will alternate with
actual temperature when it is current.
NOTE: Displayed temperature will only be current after
the pump has been running for at least two minutes.
Switching Modes
Press Temp button followed by the Light button.•
Press the same sequence to switch to the next •
mode.
Jets
Press the Jets button:
Once to activate low speed pump.•
Twice to activate high speed.•
Three times to return to turn pump off.•