Filter
Top Products
2010 Portable Spa
LTR20101001, Rev. B
Operating Your Spa
www.calspas.com
15
When rst powered up, the electronic
system will perform a self-diagnostic check
and then it will automatically heat to and
maintain a temperature of 37.5˚C until you
change the set temperature as listed in the
“Temperature Adjustment” section below.
These instructions will describe features
and options that your particular spa may
not be equipped with.
Initial Start-up
When your spa is rst powered up, it
displays some conguration codes and
then goes into priming mode (Pr will appear on the
display panel). This mode lasts up to four minutes and
then the spa begins to heat to its pre -programmed
temperature of 37.5˚C. You can exit the priming mode
early by pressing UP or DOWN buttons.
Temperature Adjustment (26.0˚C -
40.0˚C)
The start-up temperature is set at 37.5˚C. The last
measured temperature is constantly displayed on
the control panel. Note that the last measured spa
temperature is displayed. The displayed temperature
will be updated when the pump has been running for
at least two minutes.
Press the UP or DOWN buttons once to display the
set temperature. Each time either button is pressed
again, the set temperature will increase or decrease
depending on which button is pressed. After three
seconds, the control panel will automatically display
the last measured spa temperature.
Time
When time hasn’t been programmed, the TIME icon
ashes. To set the time, press the TIME button and
then the MODE/PROG button. Use the UP and DOWN
buttons to adjust time. See the next page for more
detailed instructions.
Standard, Economy, Sleep, and
Standby Modes
Mode/Prog: This button is used to switch between
standard, economy, and sleep modes.
Press MODE/PROG to enter mode programming.1.
Press the DOWN button to cycle through to the 2.
desired mode.
8005 and 9005 Electronic Control Operation
Press MODE/PROG to conrm selection.3.
Standard Mode: This is programmed to maintain
the desired temperature. Note that the last measured
spa temperature displayed is current only when the
pump has been running for at least two minutes. The
“STAND” icon will display until the mode is changed.
Economy Mode: Economy mode heats the spa to the
set temperature only during lter cycles. The “ECON”
icon will display until the mode is changed. Pressing
the JETS 1 button while in economy mode puts the
spa in standard-in-economy mode, which operates the
same as standard mode but reverts back to economy
mode automatically after one hour. During this
time, pressing the MODE/PROG button will revert to
economy mode immediately.
Sleep Mode: Sleep mode heats the spa to within 11˚C
of the set temperature only during lter cycles. The
“SLEEP” icon will display until the mode is changed.
Standby Mode: Pressing “Warm” or “Cool” then
“Jets 2” will turn off all spa functions temporarily. This
is helpful when changing a lter. Pressing any button
resets the spa.
Jets 1 and Jets 2
Press the JETS 1 button once to turn pump 1 on or off
and to shift between low and high speeds if equipped.
If left running, the low speed turns off after two hours
and the high speed turns off after 15 minutes. On
non-circulation systems, the low speed of pump 1
runs when the blower or any other pump is on. It may
also activate for at least two minutes every 30 minutes
to detect the spa temperature and then to heat to
the set temperature if needed, depending upon the
mode. When the low speed turns on automatically, it
cannot be deactivated from the panel; however, the
high speed may be started.