Filter
Top Products
4-5 OPTIONAL BUMPER GUARD
INSTALLATION (Figure 4-5)
Using bumper as a template, mark and drill 7/16”
holes through side of deck. Bolt bumper to deck as
shown with heads of bolts to the underside of deck.
4-6 OPTIONAL OFFSET TONGUE
INSTALLATION (Figure 4-6)
Position mounting bracket along front edge of
deck as shown and mark hole locations. Drill 7/16”
holes through top and side of deck. Attach bracket to
deck with bolts provided. Attach tongue to bracket
and deck lug. The leveling rod must be moved from
the center pull location to the outer lug on the exle
assembly. Connect leveling rod between tongue lug
and axle lug with threaded end to the rear. Nuts on
tongue and leveling rod should be snug, not tight, to
allow tongue and leveling rod to pivot.
4-3 OPTIONAL FRONT ROLLER
INSTALLATION (Figure 4-4 )
Bolt rollers to deck front lip placing back plate on
opposite side of deck lip. Bolts should be installed
with head to underside of cutter.
4-4 OPTIONAL REAR ROLLER
INSTALLATION (Figure 4-4)
Bolt roller to rear deck band placing back plate to
underside of deck. Bolts should be installed with
head to underside of cutter.
17
Figure 4-4
Front and Rear Roller Installation
Front Roller Assemblies
Rear Roller Assembly
Figure 4-5
Bumper Guard
Figure 4-6 Offset Tongue
Mounting
Bracket
3/8 x 1”
Bolts
3/8” Locknuts
1/2 x 1-1/4”
Bolt
1/2 x 1-1/4”
Bolt
Leveling Rod
1/2” Locknut
Offset
Tongue
Outer Lug For
Offset Tongue