Filter
Top Products
16
Battery Charging Oil Pressure LOW
Water Temperature Water in Fuel Glow Plug ON
4.3—HOUR METER
The hour meter (2,Fig. J) indicates the number of hours the
tractor has been operated. It can be used to keep track of
maintenance intervals and the amount of time required to
perform various tasks. The hour meter operates whenever the
ignition key is in the “on” position.
Your I-Trim Mower maybe equipped with a digital hour meter.
This meter will display a signal after 5 hours and every 25
hours thereafter, recommending that you perform maintanncel
and lubricate the mower. (see sec.7). The display will
automaticly reset after 2 additional hours of run time.
4—CONTROLS
4.1—IGNITION SWITCH
Insert key in switch (1, Fig.J) and turn clockwise to on
position and wait until the glow plug light turns off. After light
turns off, turn key clockwise as far as it will go to start engine,
then release. The deck rotation control switch must be in the
off position, the traction control pedal in the neutral position
and a operator must be sitting on the seat before starting
engine.
Do not hold key in “ON” position more than 15 second at a
time.
Key should be removed when tractor is not in use to prevent
unauthorized operation.
Refer to section “5.2” for complete starting information.
4.2—INDICATOR LAMPS
After engine is started, illumination of any indicator lamp will
indicate a problem (3, Fig J). Stop engine and correct
problem.
When Key is turned to “ON” the Battery Charging, Glow Plug
ON, and the Oil Pressure indicator lamps should illuminate.
After 5 seconds, the Glow Plug ON light should turn off (Fig
K).
FIGURE J
1
2
4
3
9
7
FIGURE K
5 6
8
10