Filter
Top Products
14
1. Remove rear RH wheel to replace battery. Install
battery with side mount terminals facing toward
engine. See Fig F.
2. Place battery hold down strap over bolts and secure
with flat washers and hex nuts. Do not over-tighten.
3. Connect the red ignition wire to the positive (+)
terminal of the battery. Attach the engine ground wire
and frame ground wire to the negative (–) terminal of
the battery.
2.8—BATTERY
Follow the battery manufacture’s instructions on
safety, maintenance and installation procedures.
The I-Trim is shipped with a Exide Model 60 Premium,
Type 78-60. Only replace with an equivalent battery.
2.6—ENGINE CRANKCASE
Crankcase oil has been installed at the factory. However it
is recommended that the engine be checked for proper oil
level before starting. Refer to separate engine manual
included with each I-Trim Mower.
2.7—HYDRAULIC OIL
1. The hydraulic oil has been installed in the oil tank
(1, Fig. G) at the factory, however it is recommended that
the oil level be check before operation.
2. Check oil level by removing pipe cap. The oil level should
be at the bottom edge of the screen. If required, add a
small amount of oil to the tank. and replace cap.
Recommended oil is ISO 68 Hydraulic grade oil.
FIGURE F
2.9—GUARD FOR DECK DISCHARGE
Each I-Trim Deck is supplied with a safety guard for the
rear discharge area. These guards are supplied to
prevent accidental insertion of a person’s foot and need to
be installed as shown in Fig. G.
Guard
2.10—SCREENBOX FOR RADIATOR
The I-Trim may be supplied with a pivoting rear screenbox
as shown in Fig. H. The screenbox needs to be installed
onto lower pivot brackets and secured with supplied
cables and snap-latches.
FIGURE H
FIGURE G