Filter
Top Products
11
CE Export Safety Icons
Danger: Thrown Objects.
This machine is capable of
throwing objects and debris. Keep
bystanders away.
Danger: Dismemberment.
This machine can amputate limbs.
Keep bystanders and children away
when engine is running.
Danger: Dismemberment.
This mower deck can amputate
limbs. Keep hands and feet away
from blades.
Danger: Carbon Monoxide
Poisoning.
Do not operate the engine in an
unventilated area.
Danger: Fire Hazard.
Keep unit free of grass, leaves and
excess oil. Do not add fuel while
engine is hot or running. Stop
engine and allow to cool for at least 3 minutes prior to
adding fuel. Do not add fuel indoors, in an enclosed
trailer, garage or other enclosed areas. Clean up
spilled fuel. Do not smoke while operating this
machine.
Danger: Dismemberment.
This machine can crush and cut.
Keep hands away from belts and
pulleys.
Safety Icons
The alert symbol is used to identity safety
information about hazards that can result in personal
injury. A signal word (DANGER, WARNING, or
CAUTION) is used with the alert symbol to indicate
the likelihood and the potential severity of the injury.
In addition, a hazard icon may be used to represent
the type of hazard. An explanation of hazard levels
and icons are as follows:
DANGER
This indicates a hazard which, if not avoided, will
result in serious injury or death.
WARNING
This indicates a hazard which, if not avoided, could
result in serial injury or death.
CAUTION
This indicates a hazard which, if not avoided, might
result in minor or moderate injury.
CAUTION or NOTICE
These messages presented without the alert symbol
indicate a situation where the unit or property could be
damaged.
Hazard
Safety
Icon
Alert
Toxic
Fumes
Read the
Manual
Open flame
hazard
Fire
Hazard
Amputation
Rotating
Parts
Amputation
Hand in
Blade
Hazard
Safety
Icon
Amputation
Foot in
Blade
Thrown
Objects
Maintain
a safe
distance
Keep
children
away
Hot
surface
Wear
Protective
Gear
Pinch
Point
North American Safety Icons
Rollover
Hazard
Overhead
Obstacles
Safety Icons
Warning: Read Operator’s
Manual.
Read and understand the
Operator’s Manual before using
this machine.
Warning: Remove Key Before
Servicing.
Remove the key and consult
technical literature before
performing repairs or maintenance.
Danger: Machine Rollover.
Operating on steep slopes can
cause sliding and loss of steering,
control and rollover. Do not use
this machine on slopes greater than 15°. This limit
was determined per CEN Standard EN 836:1997,
Section 5.2.2 and is based on the EN 836 Stability
Test procedure described in Section 4.2.4.2. The 15
degree “limit of stability” is equal to 50% of the angle
at which machine lift-off occurred in static tests. Actual
dynamic stability may vary depending on operating
conditions.
Danger: Machine Rollover.
Do not operate on any slopes when
wet or slippery. Do not operate
near drop-offs or near water.
Warning: Hot Surface
Avoid contact with engine and
hot surfaces. Wait for unit to cool
before touching.
Not for
Reproduction