Filter
Top Products
12
BASIC OPERATION
ZAP
The ZAP control is a convenient way to eliminate a known undesirable
metal object from detection.
To demonstrate the ZAP control:
1) Set the detector in All-Metal Mode
Note: ZAP functions in all modes, but is best demonstrated
first from the All-Metal Mode.
2) Pass the searchcoil over an undesirable object.
3) Notice the Target Indication
Note: You can only ZAP objects that register under the
five left-most segments (from Iron to Zinc).
4) Press ZAP. An "R" appears under the segment to be eliminated.
5) Pass the searchcoil over the same object again.
The undesirable object is eliminated from detection
The ZAP control is easy to use in the field. As you are detecting, and
encounter an object which you wish to eliminate from detection,
simply press the ZAP touch pad after detecting the object.
The ZAP control eliminates the most-recently detected object category
from detection. The category eliminated is indicated with an "R".
HEADPHONE JACK
Using headphones (not
included) with your
metal detector makes it
easier to identify subtle
changes in the
threshold levels for
better detection results,
and also reduces drain
on the batteries. The
Discovery 2200 Metal
Detector has a stereo
headphone jack
located at the rear of
the case.
This device is to be
used with interconnect-
ing cables/headphone
cables shorter than
three meters.