Filter
Top Products
7
ATTACHING THE CHIPPER CHUTE
(Model 465A 8 H.P. chipper shredder only)
Figure 4
1. Remove the three cupped washers and hex
nuts from the weld studs beside (A) the opening
on the left side of the housing.
See Figure 4
2. Remove the two hex bolts, lock nuts, and flat
washers from the two holes on the upper end of
the brace.
3. Place the chipper chute over the weld studs so
the slot on the chute is towards the bottom.
Align the three holes on the chute with the
three weld studs.
4. Replace the three cupped washers (cupped
side against the chipper chute) and hex nuts
that you removed in step 1. Do not tighten the
nuts at this time. Make sure to place the cupped
side of the washer against the chipper chute.
5. Your unit is shipped with one end of the brace
already secured to the lower frame. Loosen the
bolts securing the brace to the frame.
6. Align the holes on the chute with the holes on
the brace.
7. Attach brace to chipper chute with the hardware
removed earlier from the brace. See the
illustration above for proper order. Tighten.
8. Tighten the bolts securing the brace to the
frame.
9. Tighten the three nuts on the weld studs holding
the chipper chute to the flail housing.
ALL MODELS
1. To attach the bag, place the opening of the bag
over the chute deflector so it completely covers
the chute deflector.
See Figure 5
2. Depress the plunger on the drawstring, and pull
on the drawstring until the bag is tight around
the chute opening. Release plunger to lock it
into position.
See Figure 5
Figure 5
3. Fill engine with oil as instructed in separate
engine manual included with your unit.
Brace
Weld Stud (A)
Weld Stud (A)
Weld Stud (A)
Chipper
Chute
Hex Bolt
Flat Washer
Hex Nut
Frame