Filter
Top Products
39 - ENG
pulsate. Clean the nozzle immediately
using the nozzle kit supplied and the
following instructions:
1. Shut off the pressure washer and
turn off the water supply.
2. Pull trigger on gun handle to relieve
any water pressure.
3. Disconnect the spray wand from
the gun.
4. Remove the high-pressure nozzle
(K) from the spray wand. Remove
any obstructions with the nozzle
cleaning tool provided and
backflush with clean water.
12
K
K
N
5. Direct water supply (N) into spray
wand to backflush loosened
particles for 30 seconds.
6. Reassemble the nozzle to the
wand.
7. Reconnect spray wand to gun and
turn on water supply.
8. Start pressure washer and place
spray wand into high pressure
setting to test.
CLEAN THE WATER INLET
FILTER (FIG. 8)
This screen filter should be checked
periodically and cleaned if necessary.
1. Remove filter by grasping end and
removing it from water inlet of
pump.
2. Clean filter by flushing it with water
on both sides.
3. Re-insert filter into water inlet of
pump. NOTE: Cone side faces out.
NOTE: Do not operate the pressure
washer without filter properly installed.
STORAGE
ENGINE
Consult the Engine Owners Manual for
manufacturer’s recommendations for
storage.
PUMP (FIG. 13)
NOTICE: The manufacturer recom-
mends using a pump protector/win-
terizer when storing the unit for more
than 30 days and/or when freezing
temperatures are expected. FREEZE
DAMAGE IS NOT COVERED BY THE
WARRANTY.
Pump protector/winterizer is usually
available at the store where the pressure
washer was purchased. If a pump
protector/winterizer is not available, RV
antifreeze needs to be run through the
pump as outlined in the steps below.
NOTE: Using a pump protector/
winterizer or RV antifreeze is to provide
proper lubrication to the internal seals
of the pump regardless of temperature
or environment.
1. Obtain a funnel, 6 ounces (170mL)
of RV Antifreeze, and a 16" to
36" (40-91 cm) section of garden
hose with a male hose connector
attached to one end.
13
NOTICE: Risk of Property Damage.
Use only RV Antifreeze. Any other
antifreeze is corrosive and can damage
the pump.
2. Disconnect the spark plug wire.
3. Connect the length of garden hose
to the water inlet of the pump.