Filter
Top Products
37 - ENG
NOTICE: Risk of property damage.
Never pull water supply hose to move
pres sure washer. This could damage
hose and/or pump inlet.
• DO NOT use hot water, use cold
water only.
• Neverturn water supplyoffwhile
pressure washer engine is running
or damage to pump will result.
• DO NOT stop spraying water for
more than two minutes at a time.
Pump operates in bypass mode
when spray gun trigger is not
pressed. If pump is left in bypass
mode for more than two minutes
internal components of the pump
can be damaged.
If you do not understand these
precautions, please contact our
customer service department at
www.BlackandDecker-la.com!
Prior to starting, refer to your engine
manual for proper starting procedure.
1. In a well ventilated outdoor area
add fresh, high quality, unleaded
gasoline with a pump octane rating
of 86 or higher. Do not overfill. Wipe
up spilled fuel before starting the
engine. Refer to Engine Owners
Manual for correct procedure.
2. Check engine oil level. See Engine
Owners Manual for correct
procedure.
3. Connect the water hose to the
water source. Turn the water
source on to remove all air from
the hose. When a steady stream
of water is present, turn the water
source off.
4. Verify the filter screen (M) is in
water inlet of pump.
NOTE: Cone side faces out.
M
8
5. Connect high pressure hose (C) to
pump outlet (I).
C
9
I
6. Connect water source (N) to pump
inlet (J). NOTE: Water source must
provide a minimum of 5 gallons per
minute at 20 psi.
N
10
J
WARNING: To reduce the
possibility of contamination always
protect against backflow when
connected to a potable water system.
7. Choose the correct nozzle for the
job to be performed. See How
To Use spray Wand instructions
in this section. NOTE: If applying
a chemical or cleaning solution,
see How To Apply Chemicals/
Cleaning Solvents instructions in
this section.
8. Turn water source on.
NOTICE: Risk of property damage.
Failure to do so could cause damage
to the pump.
9. Remove all air from the pump and
high pressure hose by depressing
trigger until a steady stream of
water is present.
10. Start engine. See Engine Owners
Manual for correct procedure.