Black & Decker BDG3100-B3 Pressure Washer User Manual


 
35 - ENG
NOZZLE
COLOR
SPRAY
PATTERN
USES SURFACES*
Red
powerful pinpoint
for spot cleaning
of hard, unpainted
surfaces or for
high reach areas
unpainted metal
or concrete;
DO NOT use on wood
Yellow
15˚ intense cleaning
of unpainted
hard surfaces
grills, driveways, concrete
or brick walkways,
unpainted brick or stucco
White
40˚ cleaning of
painted or delicate
surfaces
auto/RV, marine, wood,
painted brick and stucco,
vinyl, painted siding
Black
low pressure applies cleaning
solutions
low pressure spray is
safe on all surfaces.
Always verify
compatibility of cleaning
solution prior to use.
*NOTICE: The high pressure spray from your pressure washer is capable of
causing damage to surfaces such as wood, glass, automobile paint, auto striping
and trim, and delicate objects such as flowers and shrubs. Before spraying,
check the item to be cleaned to assure yourself that it is strong enough to resist
damage from the force of the spray.
HOW TO APPLY CHEMICALS/
CLEANING SOLVENTS (FIG. 7)
Applying chemicals or cleaning solvents
is a low pressure operation. NOTE: Use
only soaps and chemicals designed
for pressure washer use. Do not use
bleach.
To Apply chemicals (BDG2600-B3):
1. Press detergent siphon hose (F)
onto barbed fitting located near
high pressure hose connection of
pump as shown.
F
7
2. Place other end of detergent siphon
hose with filter on it into container
holding chemical/cleaning solution.
NOTE: For every 7 gallons of water
pumped 1 gallon of chemical/
cleaning solution will be used.
3. Install low pressure (black) nozzle
into quick connect fitting of spray
wand, see How To Use Spray
Wand paragraph in this section.
4. After use of chemicals, place
detergent siphon hose into
container of clean water and draw
clean water through chemical
injection system to rinse system
thoroughly. If chemicals remain in
the pump it could be damaged.
Pumps damaged due to chemicals
will not be covered under warranty.
NOTE: Chemicals and soaps will not
siphon if the black soap nozzle is not
installed on the spray wand.