Filter
Top Products
38- ENG
WARNING: Risk of unsafe
operation. If engine does not start
after two pulls, squeeze trigger of
gun to relieve pump pressure. Pull
starter cord slowly until resistance
is felt. Then pull cord rapidly to avoid
kickback and prevent hand or arm
injury.
11. Depress trigger on gun to start
water flow.
WARNING: Risk of unsafe
operation. Stand on a stable surface
and grip gun/spray wand firmly with
both hands. Expect the gun to kick
when triggered.
12. Release trigger to stop water flow.
WARNING: Risk of injury from
spray. Always engage the trigger lock
(O) when gun is not in use. Failure
to do so could cause accidental
spraying.
11
O
SHUTTING DOWN
1. After each use, if you have applied
chemicals, place detergent siphon
hose into container of clean water
and draw clean water through
chemical injection system to rinse
system thoroughly.
NOTICE: Risk of property damage.
Failure to do so could cause damage
to the pump.
2. Turn engine off. See Engine
Owner’s Manual.
NOTICE: Risk of property damage.
NEVER turn the water off with the
engine running.
3. Turn water source off.
4. Pull trigger on spray gun to relieve
any water pressure in hose or spray
gun.
5. See Storage section in this manual
for proper storage procedures.
MAINTENANCE
WARNING: Risk of burn hazard.
When performing maintenance, you
may be exposed to hot surfaces,
water pressure or moving parts that
can cause serious injury or death.
WARNING: Risk of fire hazard.
Always disconnect, spark plug wire,
let the engine cool and release all
water pressure before performing
any maintenance or repair. The
engine contains flammable fuel. Do
not smoke or work near open flames
while performing maintenance.
To ensure efficient operation and longer
life of your pressure washer, a routine
maintenance schedule should be
prepared and followed. If the pressure
washer is used in unusual conditions,
such as high-temperatures or dusty
conditions, more fre quent maintenance
checks will be required.
ENGINE
Consult the Engine Owners Manual for
the man u fac tur er's recommendations
for any and all maintenance. NOTE: The
engine drain plug is located at the rear
of the unit.
PUMP
The pump was filled with oil at the factory.
The pump on this unit is maintenance
free and requires no oil. If there is a
problem with the pump contact us at
www.BlackandDecker-la.com
CONNECTIONS
Connections on pressure washer hoses,
gun and spray wand should be cleaned
regularly and lubricated with light oil or
lithium grease to prevent leakage and
damage to the o-rings.
NOZZLE CLEANING (FIG. 12)
If the nozzle becomes clogged
with foreign materials, such as dirt,
excessive pressure may develop. If
the nozzle becomes partially clogged
or restricted, the pump pressure will