Filter
Top Products
36- ENG
To Apply chemicals (BDG3100-B3):
1. Press detergent siphon hose (F,
Figure 7A) onto barbed fitting
located near high pressure hose
connection of pump as shown.
F
7A
2. Fill your detergent tank (L,
Figure7B) with pre-mixed cleaning
solutions designed for pressure
washer use.
7B
L
R
F
7C
L
3. Place other end of detergent
siphon hose (F) with filter (R) on it
into detergent tank (L). Make sure
filter (R) is fully submerged into
cleaning solution.
NOTE: For every 7 gallons of water
pumped 1 gallon of chemical/
cleaning solution will be used.
4. Install low pressure (black) nozzle
into quick connect fitting of spray
wand, see How To Use Spray
Wand paragraph in this section.
5. After use of chemicals, refill your
detergent tank with clean water
and operate your chemical injection
system to rinse it thoroughly. If
chemicals remain in the pump
it could be damaged. Pumps
damaged due to chemicals will not
be covered under warranty..
NOTE: Chemicals and soaps will not
siphon if the black soap nozzle is not
installed on the spray wand
STARTING (FIG. 8–11)
WARNING: To reduce the risk
of injury, read the pressure washer
instruction manual and the engine
instruction manual before starting
pressure washer.
DANGER: Risk of fluid injection
and laceration. When using the high-
pressure setting, DO NOT allow
the high-pressure spray to come in
contact with unprotected skin, eyes,
or with any pets or animals. Serious
injury will occur.
• Yourwasheroperatesatfluidpres-
sures and velocities high enough to
penetrate human and animal flesh,
which could result in amputation or
other serious injury. Leaks caused
by loose fittings or worn or dam-
aged hoses can result in injection
injuries. DO NOT TREAT FLUID
INJECTION AS A SIMPLE CUT!
See a physician immediately!
WARNING: Risk of Fire,
Asphyxiation and Burn. Never fill fuel
tank when engine is running or hot.
Do not smoke when filling fuel tank.
• Neverfillfueltankcompletely.Fill
tank to 1/2" )12.7mm) below bot-
tom of filler neck to provide space
for fuel expansion. Wipe any fuel
spillage from engine and equip-
ment before starting engine.
• Never run engine indoors or in
en closed, poorly ven ti lat ed areas.
En gine exhaust con tains carbon
mon ox ide, an odorless and deadly
gas.
• DO NOT let hoses come in con-
tact with very hot engine muffler
during or immediately after use of
your pressure washer. Damage to
hoses from contact with hot engine
surfaces will NOT be covered by
warranty.