Filter
Top Products
16
w ww.b is se ll .c om 8 00 .2 37 .7 69 1
5
The only tool you’ll need to assemble your
vacuum cleaner is a Phillips screwdriver.
Attach handle to vacuum
1. Locate the vacuum handle and remove the
screw packet taped to the handle.
2. Stand the vacuum upright and from the rear
of the unit, slide the base of the handle firmly
into the grooves at the top of the vacuum
body.
3. Ensure the handle fits firmly to the vacuum
body. If there are any gaps, continue to push
firmly until the handle is secure.
4. Insert the provided screw into the existing
hole, attaching the handle to the body of the
vacuum. Tighten securely with a screwdriver.
Attach vacuum hose and tools
1. Slide the end of the hose into the hose wand
base. Snap the hose into the hose clip.
Note: The vacuum will not operate effec-
tively unless the hose wand is firmly
attached.
2. Place the crevice tool on the storage clip on the
left side of the tank (when viewing vacuum from
rear.)
3. Place the contour tool on the storage clip located
near the back of the upper handle.
4. Place the dusting brush on the storage clip
located on the lower cord wrap.
5. Wrap power cord around cord wraps.
Assembly
2
1
4
3
4
5
2