Filter
Top Products
11
w ww.b is se ll .c om 8 00 .2 37 .7 69 1
Replace drive belt
1. Unplug the vacuum from electrical outlet.
2. With rotating floor brush removed from vac-
uum cleaner (refer to 10 steps 1-4 of check
rotating floor brush and drive belt), grasp
old drive belt and remove from motor pulley.
Discard the old drive belt.
3. Place new drive belt over motor pulley and
loop other end over rotating floor brush in
the space between the bristles.
NOTE: It is important that you use
only genuine BISSELL replacement
belts. Generic belts may not meet the
exact specifications required to keep
your vacuum operating at its peak
performance. The use of unbranded
belts could lead to early failure of the
vacuum and could void your warranty.
4.
Pull the rotating floor brush firmly into
position, stretching the drive belt, and place
ends of rotating floor brush down into the
slots on sides as shown. Alignment of brush
ends in slots may be necessary to fully
insert the brush.
5. Turn rotating floor brush by hand several
times in the direction of motor pulley. If
properly installed, drive belt will center itself
on rotating brush crown.
6. Replace brush cover and all five screws.
Maintenance and care
2
Motor
Pulley
3
4