Filter
Top Products
370310 F112003A
19
14.
C
HECKS
-
Adjust the belt and cable control tension after the first few working hours to
compensate initial loosening.
-
Briefly operate all the machine's components to detect any abnormal noises
or overheating.
- During the initial running in period avoid heavy-duty usage to encourage
proper settling of the mechanical parts.
-
Never neglect maintenance operations after work and carry out all pre-
scribed checks regularly.
A
) T
IRE PRESSURE
Regularly check the tire pressure. If both sets of tires are not inflated to average
pressure the machine will tend to travel sideways during operation.
B
) C
ABLE CONTROL ADJUSTMENT
To adjust the cables place the machine on flat ground, switch off the engine and
disconnect the wire from the spark plug.
B1)BLADE CONTROL CABLE
Make sure that there is no play between the upper end of the cable and the ad-
justment screw. If there is, or if the cable has stretched, restore to ideal position us-
ing the relative adjustment screw(Fig. 5, ref. A)
If adjustment using the relative screw proves ineffective, the belts, and hence the
engine mounting, must be adjusted. To perform this operation refer to section 14C
“ BELT REPLACEMENT AND ADJUSTMENT” of this manual.
B2) FORWARD CONTROL CABLE
Make sure that there is no play between the upper end of the cable and the ad-
justment screw. If there is, or if the cable has stretched, restore to ideal position us-
ing the relative adjustment screw ( Fig. 5, ref. A).
If adjustment using the relative screw proves ineffective, the belts, and hence the
engine mounting, must be adjusted. To perform this operation refer to section 14 C
“ BELT REPLACEMENT AND ADJUSTMENT” of this manual
Fig.5