Filter
Top Products
Step 6
BK19
19
Each wall panel has a crimped rib on
one side. The crimped rib should go
under the rib of the panel that follows
it. The rear header supports the rear
wall and roof.
1Fasten the wall panels at the top
and bottom with screws.
2Fasten overlapping ribs using two
screws and a bolt with nut.
3Positioning the rear header,
with
small flange on top,
fasten to rear
wall angle, using seven screws.
●●
●●
● 9441 Rear Header (one)
●●
●●
● 9445 Wall Panel (two)
● Parts Needed For ●
Wall Panels/Rear Header
STEP
3
9441
STEP
2
Crimped Rib
Underneath
STEP
1
Nut
STEP
3
Panels rest on
frame as shown
Screw
Bolt
9445
9445