Filter
Top Products
16
Step 3
BJ16
The floor frame at the front of building
is made up of two pieces. Proceed as
follows:
1Center the ramp on top of the front
floor frame. Join the frames by in-
serting four screws.
2Place the floor frames on the foun-
dation. Assemble the four corners of
the floor frame using two screws at
each corner as shown.
3Measure the floor frame diagonally.
When the diagonal measurements
are equal, the floor frame is square.
NOTE
Do not fasten the floor frame to
your foundation at this time. You
will anchor the building after it is
erected.
The floor frame
must be square
and level
or holes will not align.
● Parts Needed For ●
Floor Frame Assembly
●●
●●
● 8984 Side Floor Frame (two)
●●
●●
● 9429 Ramp (one)
●●
●●
● 9430 Front/Rear Floor Frame (two)
STEP
1
Level
9430
8984
9430
8984
8984
9430
9429
Screw
FRONT
When Diagonal Measurements are
Equal the Floor Frame is Square.
STEP
2
STEP
3