Filter
Top Products
AR-EXP-CUMMINS-07-00 OWNERS MANUAL
Page 29
tenance.
Daily or Refueling - Maintenance Check
(4)
• Air Intake Piping - Inspect
• Air Tank and Reservoirs - Drain
• Cooling Fan - Check/Correct
• Crankcase Breather Tube - Inspect
• Drive Belts - Check/Correct
• Engine Coolant Level - Check/Correct
• Engine Lubricating Oil Level - Check/Correct
• Fuel-Water Separator - Drain
Every 250 Hours or 3 Months - Maintenance
Check
(1, 4)
• Air Cleaner Restriction - Check/Correct
• Air Compressor Mounting Hardware - Check/Correct
• Charge Air Cooler - Check/Correct
• Charge Air Piping - Check/Correct
• Fuel Injection Pump Mounting Hardware - Check/
Correct
• Lubricating Oil and Filters - Change
• Radiator Hoses - Check
Every 500 Hours or 6 Months - Maintenance
Check
(2, 3, 4)
• Engine Coolant - Antifreeze Check
• Fuel Filter, Canister-Type - Replace
• Fuel Filter, Spin-on-Type - Replace
• Lubricating Oil and Filters - Change
Every 1000 Hours or 1 Year - Maintenance Check
(4)
• Cooling Fan Belt Tensioner - Check/Correct
• Fan Hub, Belt-Driven - Check/Correct
• Overhead Set - Adjust
Every 2000 Hours or 2 Years - Maintenance Check
(3, 4)
• Air Compressor Discharge Line - Check/Correct
• Cooling System - Drain, Flush, and Fill
• Vibration Damper, Rubber - Check
Vibration Damper, Viscous - Check
1. NOTE: The lubricating oil and lubricating oil filter
interval can be adjusted based on application, fuel
consumption, gross vehicle weight, and idle time.
For engines whose aspiration is jacket water-
cooled, turbocharged only, or natural, refer to
Table in the Oil Drain Intervals section.
2. The lubricating oil and lubricating oil filter interval
can be adjusted based on application, fuel con-
sumption, gross vehicle weight, and idle time. For
engines whose aspiration is charge air cooled,
refer to Table in the Oil Drain Intervals section.
3. Antifreeze check interval is every oil change or
500 hours or 6 months, whichever occurs first.
The operator must use a heavy-duty year-round
antifreeze that meets the chemical composition of
GM6038M. The antifreeze change interval is 2
years, 2000 hours, or whichever occurs first. Anti-
freeze is essential for freeze, overheat, and corro-
sion protection.
4. Follow the manufacturer's recommended mainte-
nance procedures for the starter, alternator, gen-
erator, batteries, electrical components, charge air
cooler, radiator, air compressor, air cleaner, refrig-
erant compressor, and fan clutch. Refer to the
Component Manufacturers in Section M.