Filter
Top Products
GB - 22
DEFLECTOR REMOTE (921002, 003, 004)
Deflector must stay in selected position while throwing
snow.
If deflector does not stay in set position:
1. Tighten nut beneath control panel to increase
pressure on deflector control (Figure 27).
If deflector does not follow full range of travel:
1. Push deflector remote all the way forward.Pull
deflector all the way back.
2. Loosen adjusting nuts on cable support bracket
underneath the dash panel (Figure 27).
3. To adjust the deflector lower:
Slide cable down. Tighten bottom nut.
4. To adjust deflector higher:
Slide cable up. Tighten top nut.
5. Check travel and repeat adjustment as
necessary.
DISCHARGE CHUTE (921002, 003, 004)
If chute does not stay in position while throwing snow
or if chute does not rotate freely, adjust the cable under
the control panel so the chute lock fingers engage or
disengage the locking gear.
If chute does not stay in position:
Loosen the cable by loosening the lower adjustment
nut, and then tightening the upper adjustment nut
against the bracket (Figure 28).
Figure 26
1.Top Jam Nut
2.Bottom Jam Nut
3.Cable Adjuster
1
2
No Slack
OS7170
3
Figure 27
Tighten nut.
2
1
1.Adjusting Nuts
2.Cable Support Bracket
OS7175
921002, 003, 004
Tighten upper
adjustment nut.
Loosen lower
adjustment nut.
Figure 28
OS7180
921002, 003, 004