Filter
Top Products
EN - 29
REMOTE DISCHARGE
DEFLECTOR CONTROL
ADJUSTMENT
(920014, 020, 021)
(Figures 28 and 29)
Deflector must stay in selected position while
throwing snow.
If deflector does not stay in set position:
1. Tighten nut beneath control panel to
increase pressure on deflector control
(Figure 28).
.
If deflector does not follow full range of travel:
1. Push deflector remote all the way to rear
most position.
2. Loosen adjusting nuts on remote
deflector cable attached to the chute
deflector (Figure 29).
3. To adjust the deflector lower:
Loosen bottom adjustment nut and
tighten top adjustment nut.
To adjust deflector higher:
Loosen top adjustment nut and tighten
bottom adjustment nut.
4. Check the deflectors range of travel and
repeat adjustment as necessary.
Figure 27
OS8215
1. Wing Knob
2. Discharge Chute Deflector
3. Discharge Chute
1
2
3
Figure 28
Adjustment Nut
Figure 29
2
1
1. Adjusting Nuts
2. Cable Support Bracket
3. Remote Deflector Control Cable
3