Filter
Top Products
EN - 12
Install Remote Deflector Cable
(920014, 020, 021)
(Figures 12 and 13)
1. Pull rubber seal cap away from snap
fitting (Figure 12).
.
2. Install snap fitting into cable bracket’s
mounting hole located under the control
panel.
3. Position rubber seal cap over the top of
snap fitting.
4. Move deflector control lever to rear most
position.
5. Attach cable eye to pin on bottom of
deflector control lever.
NOTICE: Hold down chute deflector cap, if
needed, for more cable slack.
6. Secure cable eye to control lever with
bushing and hairpin.
7. Using the wire hook attached to the
deflector cable, hook cable to discharge
chute crank.
Figure 11
1. Chute Crank
2. Support Bracket
3. Pinion Gear
4. Spring Clip Pin
1
2
3
4
OS8060
Figure 12
1. Mounting Hole
2. Snap Fitting
3. Rubber Seal
Cap
4. Hairpin
5. Bushing
6. Cable Eye
2
1
3
4
6
5