Filter
Top Products
EN - 10
Unfold Upper Handlebar Assembly
(Figure 7)
1. Rotate the handlebar into operating
position.
NOTICE: Be careful not to damage cable
spring hooks when rotating handlebar
upward.
.
2. Install the remaining handlebar
hardware attaching the upper handlebar
assembly to the lower handlebar
(Figure 5).
3. Tighten all hardware.
4. Remove packaging around shift rod.
5. Rotate shift rod into place and tighten
hardware.
6. Connect shift rod to speed selector arm
and adjust as specified in Speed
Selector Adjustment on page 30.
7. Adjust attachment control cable as
specified in Attachment Clutch/Brake
Adjustment on page 30.
8. Adjust traction control cable as specified
in Traction Drive Clutch Adjustment on
page 33.
Connect Headlight Wire Harness
(Figure 8)
NOTICE: The headlight wire harness comes
attached to the upper handlebar assembly.
1. Route the wire harness along the interior
of the right side handlebar.
2. Connect to the engine electrical plug.
3. Press cable anchor into mounting hole in
the frame near the engine electrical
plug.
4. Secure the wire harness to the
handlebars using the cable ties attached
to the wire harness.
5. Gather excess wire harness length and
fasten together with cable tie included in
literature pack.
Install Trigger Cable Assembly
(920020)
(Figure 9)
NOTICE: Trigger cable assembly comes
attached to the Sno-Thro unit.
1. Attach remote trigger cable assembly to
upper handlebar assembly using one
1/4" x 1-1/2" oval head machine screw
and one 1/4" locking washer.
Figure 7
1
2
3
1. Shift Rod
2. Handlebar Hardware
3. Shift Rod Hardware
4. Upper Handlebar Assembly
5. Lower Handlebar
4
5
Figure 8
2
4
3
1. Wire Harness
2. Cable Tie
3. Cable Anchor
4. Engine Electrical Plug
5. Excess Wire Harness
1
5