Ariens 920013 - COMPACT 24 LE Snow Blower User Manual


 
GB - 22
Ariens Dealers will provide any service or
adjustments which may be required to keep
your unit operating at peak efficiency. Should
engine service be required, contact an Ariens
dealer or an authorized engine
manufacturer's service center.
SERVICE POSITION
(Figure 19)
Place unit on a flat level surface. Tip unit
forward onto front of auger housing for
service. Ensure unit is secure and will not tip
over. Strap and clamp onto bench if needed.
MAINTENANCE SCHEDULE
The chart below shows the recommended
maintenance schedule that should be
performed on a regular basis. More frequent
service may be required.
CHECK DUAL HANDLE
INTERLOCK
Without the engine running, press down
(engage) both clutch levers. Release
attachment clutch lever. Attachment clutch
should remain engaged until traction clutch
lever is released, then both clutches must
disengage.
CHECK FASTENERS
Make sure all hardware is tightened properly.
MAINTENANCE
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
WARNING:
Before tipping unit up onto
housing, close fuel shut-off valve, and
drain fuel tank and fuel system so no
spills will occur (see engine manual for
complete instructions). Ensure unit is
secure and will not tip over during
maintenance.
Figure 19
Service Position
OS8190
MAINTENANCE SCHEDULE
Service
Performed
Each
Use
Every
5 hrs.
Every
25
hrs.
Yearly
Check Dual
Handle
Interlock
Check
Fasteners
Check Clutch
Operation
Clean Engine
Check Engine
Oil
Change
Engine Oil**
Check Tire
Pressure
Check Auger
Gearcase
••
General
Lubrication
••
** Refer to Engine Manual for detailed
instructions.