Filter
Top Products
GB - 24
Replace Attachment Drive Belt
1. Place new belt onto attachment pulley.
NOTE: Hold down the attachment clutch
lever to make it easier to reconnect the
housing and frame.
2. Tip housing and frame back together
and secure with hex bolts.
3. Place belt onto drive pulley.
4. Replace belt fingers. Ensure that index
pins are properly seated.
5. Adjust clutch per Attachment
Clutch/Brake Adjustment on page 25.
6. Replace chute crank and secure with
spring pin.
7. Reconnect remote deflector cable to
dash control.
8. Run in the attachment belt. See Run-in
Attachment Belt on page 11.
9. Replace belt cover.
TRACTION DRIVE BELT
REPLACEMENT
1. Move PTO and power switches to OFF
position.
2. Disconnect and remove batteries.
3. Place the unit into the service position
on a level surface (see Service Position
on page 18).
4. Remove the bottom cover by removing
six cap screws.
NOTE: To gain belt clearance, remove swing
gate spacer (Figure 27) so drive plate can be
slid over until finger is out of frame and drive
plate can swing past stop hole in frame. See
Figure 28.
WARNING: AVOID INJURY. Auger
must stop within 5 seconds when
attachment lever is released or
serious injury or unit damage may
result.
Figure 25
OS2625
1
2
3
4
1. Pinion Gear
2. Belt Cover
3. Spring Pin
4. Chute Crank
CAUTION: Before tipping unit up
onto housing, both batteries must be
removed from the unit. Ensure unit is
secure and will not tip over during
maintenance.
Figure 26
OS2623
5
3
2
1
6
7
8
4
1. Traction Belt
Idler
2. Traction
Drive Belt
3. Drive Pulley
4. Belt Finger
5. Attachment
Drive Belt
6. Attachment
Pulley
7. Attachment
Idler Nut
8. Attachment
Belt Idler
4