Filter
Top Products
GB - 10
Install Remote Deflector Cable
(Figure 8 and 9)
1. Slide cable through clip on top of
discharge chute pedestal Figure 8.
2. Bend clip closed around cable.
3. Using the wire hook attached to the
deflector cable, hook cable to discharge
chute crank.
.
4. Pull rubber seal cap away from snap
fitting.
5. Install snap fitting into cable bracket’s
upper mounting hole.
NOTE: The cable mounting bracket located
underneath the control panel contains two
mounting holes. Use only the upper mounting
hole; the one closest to the dash.
6. Position rubber seal cap over the top of
snap fitting.
7. Move deflector control lever to forward
most position.
8. Attach cable eye to pin on bottom of
deflector control lever.
NOTE: Hold down chute deflector cap, if
needed, for more cable slack.
9. Secure cable eye to control lever with
washer and hairpin.
10. Test controls to be sure deflector works
properly.
NOTE: If deflector does not follow full range
of travel See Remote Discharge Deflector
Control Adjustment on page 21.
Figure 7
1. Chute Crank
2. Control Panel
3. Pinion Gear
4. Spring Clip Pin
1
2
3
4
OS2535
OS2536
Figure 8
1. Remote Deflector Cable
2. Remote Deflector Control
3. Cable Clip
4. Wire Cable Hook
5. Cable Mounting Bracket
1
3
2
4
5