Filter
Top Products
GB - 21
SHEAR BOLTS
IMPORTANT: Use only Ariens shear bolts for
replacement. Use of any other type of shear
bolt may result in severe damage to unit and
may void the warranty.
Occasionally a foreign object may enter the
auger/impeller housing and jam the auger,
breaking the shear bolts which secure the
auger to the shaft (Figure 19). This allows the
auger to turn freely on the shaft which may
help prevent damage to gear case and its
components.
Replacement
1. Align shear bolt holes in auger with
shear bolt holes in the shaft.
2. Drive shear bolt through hole. If shear
bolt was broken this will drive remaining
part from shaft.
3. Secure shear bolt with nut.
REMOTE DISCHARGE
DEFLECTOR CONTROL
ADJUSTMENT
Figure 20
If discharge deflector does not follow full
range of travel:
1. Push deflector remote all the way
forward.
2. Loosen adjusting nuts on remote
deflector cable attached to the chute
deflector (Figure 20).
3. To adjust the deflector lower:
Loosen bottom adjustment nut and
tighten top adjustment nut.
To adjust deflector higher:
Loosen top adjustment nut and tighten
bottom adjustment nut.
4. Check the deflectors range of travel and
repeat adjustment as necessary.
DISCHARGE CHUTE
If discharge chute does not stay in position
while operating, tighten nut (2) at pivot point
to increase tension on spring. See Figure 21.
Figure 18
OS0482
1. Skid Shoe
2. Skid Shoe Hardware
1
2
Figure 19
1. Auger
2. Shear Bolts
OS2610
1
2
2
Figure 20
2
1
1. Adjusting Nuts
2. Cable Support Bracket
3. Remote Deflector Control Cable
4. Discharge Deflector
3
4