Aquatic Infinity Series Hot Tub User Manual


 
10 AQUATIC INDUSTRIES, INC.
SEE ILLUSTRATION 2A
A. Install the whirlpool bath unit per the instructions provided in this manual.
CAUTION: THE TILE FLANGE DOES NOT SUPPORT THE TUB! A ledger board must be provided under
the bath rim as indicated in the installation instructions. Take care to ensure tub is not hanging from
the ledger boards, as this will void your warranty.
B. Use nails or screws to secure the flange into the studs around the bath.
C. Install water resistant drywall against the tile flange and flush to the top of the whirlpool deck. Install
the tile or other finishing materials. Apply a second bead of silicone between the first course of tile and
the bath deck.
FACTORY INSTALLED TILE FLANGE:
NOTE: Before tub is used, the whirlpool system should be cleaned in accordance
with the procedures on Page 23 of this manual.
2A
INSTALLATION INSTRUCTIONS
1. After securing tub in place, normal waste and overflow and valves are installed per normal plumbing
procedures, in accordance with all state and local standards.
2. Install standard 1-1/2" trap to drain and overflow. Before proceeding, make a final operational check by
filling tub with water to overflow and operate pump for 5 minutes. Check for leaks carefully both while pump
is running and has been turned off. Allow water to stand in tub for at least 30 minutes before draining.
AQUATIC INDUSTRIES, INC. WILL NOT BE RESPONSIBLE FOR WATER DAMAGE OF ANY KIND IN
CONNECTION WITH ONE OF OUR WHIRLPOOL BATHS.
3. All Infinity Series models are equipped with an integral Fast Fill Waterfall Spout. Purchasing a spout is
unnecessary, however, hot and cold water valves are needed. Valves can be mounted where you choose,
however, if installation is to be on the tub deck, check the back side of the tub for adequate space for
connection to water lines before drilling or cutting tub.
PLUMBING: