Filter
Top Products
AQUATIC INDUSTRIES, INC. 15
CAUTION: Before use of the pump and heater, test the GFCI for proper operation. The pump and heater should turn
off when the GFCI "Test" button is pushed.
Warning - Prolonged Immersions in Hotter Water May Induce Hyperthermia.
Hyperthermia occurs when the internal temperature of the body reaches a level several degrees above the normal
body temperature of 98.6
o
F. The symptoms of hyperthermia include an increase in the internal temperature
of the body, dizziness, lethargy, drowsiness, and fainting. The effects of hyperthermia include (1) failure to
perceive heat, (2) failure to recognize the need to exit the whirlpool, (3) unawareness of impending hazard, (4)
fetal damage in pregnant women, (5) physical inability to exit the whirlpool, (6) unconsciousness resulting in
the danger of drowning.
WARNING - The use of alcohol, drugs, or medication can greatly increase the risk of fatal hyperthermia.
INSTALLATION INSTRUCTIONS
CHROMATHERAPY LED LIGHTING:
ELECTRICAL INSTALLATION (continued):
TROUBLESHOOTING GUIDE for UNDERWATER
CHROMATHERAPY:
All Infinity models now come equipped with a digital color-changing underwater light for soothing chromatherapy.
To compliment your bathing experience, the Aquatic electronic control panel allows you to select a color according
to the desired effects.
To Turn Your Chromatherapy Lighting System ON: Press the Light Button once to turn the Chromatherapy
Light ON in Color Wash mode. A second press of the button will turn the lighting system OFF. Subsequent
presses will move the lighting system through the seven constant color modes.
• 1st Press
Color Wash: Random color blend
• 2nd Press
Off
• 3rd Press
White: clarity
• 4th Press
Off
• 5th Press
Aqua: Calm
• 6th Press
Off
• 7th Press
Violet: Inspiration
• 8th Press
Off
To replace bulb:
1. Disconnect the power to your bathtub.
2. Drain the bathtub.
3. Open the lens of the fixture using ONLY the proper tool
provided for that purpose (see Diagram 5A). Do not
attempt to remove the lens without the provided tool.
4. Replace your LED light (replacement LED lights can be
obtained from Aquatic Industries).
5. Verify “O” ring is not damaged and is properly positioned in
the groove when replacing the lens. If there is damage or
lens does not seal properly, do not refill bathtub.
NOTE: Do not twist LED light into socket. Use gentle pressure and push LED light into place.
• 9th Press
Blue: Peace
• 10th Press
Off
• 11th Press
Yellow: Hope
• 12th Press
Off
• 13th Press
Green: Harmony
• 14th Press
Off
• 15th Press
Red: Courage
5A