Filter
Top Products
7
28. Assemble the spreader shield to the front swivel brack-
ets using two 1/4" x 3/4" carriage bolts, 5/16" washers
and the two 1/4" plastic knobs. See figure 13.
29. Assemble the spreader shield to the rear swivel brackets
using two 1/4" x 3/4" hex bolts, four 5/16" washers and
two 1/4" hex lock nuts. Tighten the locknuts so that the
swivel bracket can still pivot freely. See figure 13.
FIGURE 12
FIGURE 14
HOPPER SCREEN
30. Place the hopper screen down into the hopper to help
break up clumpy material and to prevent large clumps
from reaching the bottom of the hopper and clogging the
opening. See figure 14.
SWIVEL
BRACKET
ANGLE STOP
BRACKET
1/4" x 3/4"
HEX BOLT
5/16"
WASHER
1/4" HEX
LOCK NUT
NYLON
WASHER
SHIELD
BRACKET
NYLON
WASHER
26. Attach an angle stop bracket (inside) and a swivel
bracket (outside) to the rear hole in the R.H. shield
bracket using a 1/4" x 3/4" hex bolt, two 5/16" washers,
a nylon washer and a 1/4" hex lock nut. Tighten the
locknut so that the swivel bracket can pivot freely. See
figure 12. Repeat step on L.H. shield bracket.
27. Attach a swivel bracket to the front hole in the R.H. shield
bracket using a 1/4" x 3/4" hex bolt, two 5/16" washers,
a nylon washer and a 1/4" hex lock nut. Tighten the
locknut so that the swivel bracket can pivot freely. See
figure 12. Repeat step on L.H. shield bracket.
FIGURE 11
24. Assemble the flow control gauge onto the flow control
mounting bracket using a 1/4" x 3/4" carriage bolt, a
nylon washer and the hand knob. See figure 11.
25. Push the flow control arm forward to the off position and
slide flow control mounting bracket toward hopper until
closure plate (bottom of hopper) is fully closed. Carefully
tighten the 1/4" hex lock nuts without deforming the
slots. The closure plate should open half way when the
flow control gauge is set at "5". Reposition the flow
control mounting bracket as necessary. See figure 11.
HAND KNOB
NYLON
WASHER
FLOW CONTROL
GAUGE
OFF
1/4" x 3/4"
CARRIAGE BOLT
1/4" HEX
LOCK NUTS
FLOW CONTROL
MOUNTING BRACKET
1/4" x 3/4"
HEX BOLT
5/16" WASHER
1/4" LOCK NUT
PLASTIC
KNOB
1/4" x 3/4"
CARRIAGE BOLT
FIGURE 13