Filter
Top Products
6
21. Hook the free end of the flow control rod through the hole
in the slide gate bracket located near the bottom of the
hopper. See figure 9.
FIGURE 8
FIGURE 7
18. Assemble the flow control arm to the flow control mount-
ing bracket using one 1/4" x 5/8" hex bolt and one 1/4"
hex lock nut. Do not over tighten. The flow control arm
must pivot freely. See figure 7.
19. Hook one end of the spring through the hole at the bend
in the flow control rod. Hook the other end in the hole in
the flow control mounting bracket. See figure 7.
20.Place a 5/16" flat washer over the end of flow
control rod and insert the rod through the slot in the
flow control mount bracket and through the hole in
the flow control link. Secure with a 3/32" x 3/4"
cotter pin. See figure 8.
1/4" x 5/8"
HEX BOLT
1/4" HEX LOCK NUT
EXTENSION
SPRING
FLOW
CONTROL
ROD
FLOW CONTROL
MOUNTING BRACKET
FLOW CONTROL ARM
FLOW
CONTROL
LINK
EXTENSION
SPRING
3/32" x 3/4"
COTTER
PIN
5/16" FLAT
WASHER
FLOW
CONTROL
ROD
FLOW CONTROL
MOUNTING BRACKET
22. Assemble the flow control mounting bracket and the
short handle tube to the long handle tube using two 1/4"
x 1-3/4" hex bolts, two 5/16" flat washers and two 1/4"
hex lock nuts. See figure 10. Do not tighten yet.
23. Place a handle grip on each handle tube. See figure 10.
FIGURE 9
FIGURE 10
HOPPER
SLIDE
GATE
BRACKET
FLOW
CONTROL
ROD
1/4" x 1-3/4"
HEX BOLTS
1/4" HEX
LOCK NUTS
HANDLE
TUBE
(SHORT)
HANDLE
TUBE
(LONG)
HANDLE GRIP
FLOW CONTROL
MOUNTING BRACKET
5/16"
FLAT
WASHERS
5/16"
FLAT
WASHERS