Filter
Top Products
9
IMPORTANT: Do not over bend the support rods during
the following step. Over bending will cause the steel rods
to loose supporting tension.
10. (Figure 16) Tip the hopper onto it's back to assemble
the two hopper support rods. Place the ends of each
rod into the upper and lower rear hopper tubes, bending
the rod just enough to t into the holes in the tubes.
16
ENGLISH
11. (Figure 17) Feel along the stitched ap on the hopper
bag to locate the hole in each upper hopper side tube.
Pierce a hole through both sides of the stitched aps
in alignment with the lower hole.
17
18
12. (Figure 18) Insert a 3/8" x 3" clevis pin (S) through
the lower hole in each upper hopper side tube. Next,
assemble a bag arm tube (pointing in direction shown)
onto each clevis pin and secure it with a 3/32" hair cotter
pin (O).
13. (Figure 18) Assemble a vinyl cap (V) onto the end of
each bag arm tube.
14. (Figure 19) Secure the rope to the top center of the
hopper bag frame.
19
SUPPORT
RODS
UPPER HOPPER SIDE TUBE
LOWER HOLE
3/32" HAIR
COTTER PIN (O)
3/8" x 3"
CLEVIS PIN (S)
BAG ARM TUBE
VINYL CAP