5
TOOLS REQUIRED FOR ASSEMBLY
(1) Knife or Scissors
(2) 1/2" Open End or Box End Wrenches
ASSEMBLY
All loose parts are shown on page 2. Fasteners in the parts
bag are shown full size on page 3.
Remove the hardware pack and all loose parts from the
carton and verify that all the parts and fasteners shown on
pages 2 and 3 are included.
CONTENTS
SAFETY ...........................................................................4
ASSEMBLY ...................................................................... 5
OPERATION ..................................................................11
MAINTENANCE ............................................................11
STORAGE .....................................................................12
SERVICE AND ADJUSTMENTS ...................................12
TROUBLESHOOTING ...................................................12
REPAIR PARTS .............................................................22
ASSEMBLY OF SWEEPER
Note: Right hand (R.H.) and left hand (L.H.) are determined
from the operator's position while seated on the tractor.
1. (Figure 1) Assemble the angle bracket to the sweeper
housing using a 5/16" x 3/4" hex bolt (F) and a 5/16"
nylock nut (G). Make sure the bracket is turned as
shown and aligned straight with the housing and then
tighten.
2
2. Cut off the plastic tie that holds the height adjustment
tube in place.
3. (Figure 2) Assemble the R.H. hitch tube to the sweeper
housing using two 5/16" x 1-1/2" carriage bolts (D) and
5/16" nylock nuts (G). Do not tighten yet. Repeat for
the L.H. hitch tube.
4. (Figure 3) Fasten the hitch tubes together using two
5/16" x 2-1/2" hex bolts (A), 5/16" small at washers (I)
and 5/16" nylock nuts (G). Do not tighten yet.
3
1
ENGLISH
5/16" x 3/4"
HEX BOLT (F)
5/16" NYLOCK NUT (G)
ANGLE
BRACKET
5/16" x 1-1/2"
CARRIAGE BOLT (D)
5/16" NYLOCK NUT (G)
5/16" x 2-1/2"
HEX BOLT (A)
5/16" NYLOCK
NUT (G)
5/16" SMALL FLAT
WASHER (I)