Filter
Top Products
12 Chapter 2
Getting Started
Configuring for Remote Control
RS-232 Interface Configuration
1. Press Utility > GPIB/RS-232 LAN > RS-232 Setup.
2. Press
RS-232 Baud Rate.
3. Press the desired baud rate softkey.
4. Press
RS-232 Echo Off On.
This toggles the state of the SCPI echoing on the RS-232 connection. Set as desired.
5. Press
Reset RS-232.
This deletes the data from the RS-232 buffer, discarding any unprocessed SCPI input received over
RS-232.
These RS-232 parameters are persistent states; these states are not affected by an instrument preset or power
cycle.